ProfessionalStanding Desk Assembly

Motorized sit-stand desks are heavy, have a lot of wiring, and need precise leg calibration to move smoothly. We assemble the frame, attach the desktop, run the cables, and program the height presets so it works perfectly on day one.

Also known as: standing desk assembly, sit stand desk setup, adjustable desk assembly, motorized desk assembly, height adjustable desk install, standup desk assembly

Get a Free Estimate See service areas

4.9/5 Fully Insured & Bonded

Licensed

& fully insured

Licensed & Insured Background-Checked Pros 4.9 / 5 Satisfaction Guaranteed

Upfront pricing

Clear, honest quotes before any work begins.

Licensed & insured

Vetted local pros who treat your home with care.

Done right

We stand behind every job until you are satisfied.

What you get

What’s included

Assemble the steel frame and crossbar per manufacturer spec
Attach the desktop panel and align it squarely on the frame
Route motor and controller wiring through the frame channels
Calibrate the motor system and set upper and lower height limits
Program preset height buttons for sitting and standing positions

Simple & stress-free

How it works

Build the frame

We assemble both legs, attach the crossbar, and torque every bolt so the frame is rigid and level before the top goes on.

Mount & wire

We attach the desktop, route all cables through the integrated channels, and connect the controller box according to the wiring diagram.

Calibrate & program

We run the motor calibration sequence, test up-and-down travel across the full range, and set your preferred sit and stand heights.

We can help

Problems we fix

Frame not level — desk surface tilts noticeably at standing height
Wires not routed before top is attached, making them impossible to access cleanly
Motor calibration skipped — desk stops mid-travel or shows error codes
Legs not tightened evenly, causing the frame to wobble under load

Good to know

Standing Desk Assembly — FAQ

How long does standing desk assembly take?

Most motorized desks take 60 to 90 minutes. Larger L-shaped units or those with elaborate cable management can take a bit longer.

Can you add a cable management tray at the same time?

Yes. If you have a cable spine, raceway, or under-desk tray, we will mount it and route your monitor and device cables while we are already set up.

What if the desk motor makes noise or stops working?

Noisy motors usually mean a frame alignment issue or missed calibration step. We diagnose the problem during the visit and re-run the calibration sequence if needed.

Service area