ProfessionalWashing Machine Hose Install

Rubber washing machine hoses are a known failure point — they swell, crack, and burst without warning, and a burst hose in a laundry room can flood a home in minutes. We replace old rubber hoses with braided stainless steel lines, the current best practice for every washing machine.

Also known as: washing machine hose install, washer hose replacement, laundry machine hose, braided steel washer hose, washer supply line, washing machine hose replacment

Get a Free Estimate See service areas

4.9/5 Fully Insured & Bonded

Licensed

& fully insured

Licensed & Insured Background-Checked Pros 4.9 / 5 Satisfaction Guaranteed

Upfront pricing

Clear, honest quotes before any work begins.

Licensed & insured

Vetted local pros who treat your home with care.

Done right

We stand behind every job until you are satisfied.

What you get

What’s included

Shut off washing machine supply valves
Remove old rubber hoses from both hot and cold connections
Install braided stainless steel fill hoses with proper ferrule fittings
Check valve handles for ease of shutoff in an emergency
Test connections at full pressure and run a cycle to confirm no drips

Simple & stress-free

How it works

Shut off and drain

We close the supply valves, disconnect the washer from the wall to access the connections, and drain residual water from the old hoses.

Install new hoses

We thread the braided steel hoses onto the machine inlets and the wall valves, tightening firmly without overtorquing the plastic fittings.

Test under pressure

We open the valves, start a fill cycle, and check both hose ends for any seeping while the machine fills.

We can help

Problems we fix

Swollen or blistered rubber hoses that are close to bursting
Hoses that leak at the connection ferrule due to cracked rubber washers
Supply valves that are so corroded they won't fully close in an emergency
Hoses installed with too much tension or a tight kink near the wall

Good to know

Washing Machine Hose Install — FAQ

How often should washing machine hoses be replaced?

Rubber hoses should be replaced every 3–5 years as a preventive measure. Braided stainless hoses are rated longer but should still be inspected periodically for kinks or fraying at the ends.

Do you need to pull the washer out to do this?

Usually yes — we need access to both the machine inlet fittings and the wall valves. We'll move the machine carefully and push it back into position once we're done.